Setting Time on the Norstar System

There are a couple of different ways access the time change feature, depending on the type of system you have.  A programming template is provided below if you need it.   Just cut-out the shaded areas as well as around the outside of the template.   Once cut, place the template over the top 2 rows of buttons on your 7310 or 7324 telephone (typically lines 1 and 2 on your telephone).

After you enter programming mode, all methods are pretty much the same.

Access type 1:   Press  * * TIME (8463)

Access type 2:   Press  * * ADMIN (23646)

System displays Password & enter 23646

Display shows 1.Sys speed dial

Press Next Display shows 2. Names

Press Next Display shows 3. Time and date

Press Show Display shows Time 16:24

On the Softkey under the display it says CHANGE

If you wish to change the time, press CHANGE, if not press NEXT

Once you pressed the CHANGE button the hour displays;

If you wish to change the hour, press CHANGE, if not press NEXT

Once you pressed the CHANGE button the hour is erased allowing you to enter the new time - enter the new hour in 24 hour format, when OK press NEXT

Once you pressed the NEXT button the minutes display;

If you wish to change the minutes, press CHANGE, if not press NEXT

Once you pressed the CHANGE button the minutes are erased allowing you to enter the new time - enter the new minutes, when OK press NEXT

Follow the same procedure for changing the date!

Programming template

Print this page, cut out the shaded areas with a utility knife and then cut around the outside box.  After you're done cutting, place the template over the top 2 rows on your 7310 or 7324 telephone.

Home    Services    Work Order    Products    Support    Pay Invoice    Contact Us    Specials
Resources     Telecom Resources

©2006 North Florida Communications